User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 0 14 Wohler Te c h no l o g i e s, Inc. All rights re se r ved..
45
Ch apt er 3 The “How Do I...” Chapter
Frequently As ked Q uestions
How Do I Use Presets to Change Inputs?
The AMP2-16V can be outfitted with far more inputs than can be
monitored on a 16-channel screen. While it is possible to delve into the
various menus to reconfigure which channels are monitored each time
a change is needed, this would be a time-consuming task. Fortunately
the AMP2-16 has the ability to store 32 entire system configurations as
presets, including the inputs that are being monitored. These presets can
be instantly recalled from the Main Screen as needed.
For example, suppose you need to monitor an SDI stream sometimes,
but other times you need to monitor just some of those SDI channels
along with some AES or analog inputs. You could set up one
configuration to monitor purely the SDI stream channels, and another
to monitor the mix of channels you need. If there were other inputs you
sometimes need to monitor, you could set up system configurations for
each scenario, up to a total of 32 configurations.
Since a preset is a complete system configuration, first set up all of the
parameters to be part of the preset. Then use the Preset
Management Menu :
Figure 3–17 Preset Management Menu
Configuration Selection
Menu
Main Screen
Menu
Manage
Presets
Preset Management Menu
Preset Management Menu
Save / ExitHelp Cancel
Preset 4:
User Preset 4
Preset 1:
User Preset 1
Preset 1:
User Preset 1
Current Config
Current Settings
Preset 1:
User Preset 1
Preset 4:
User Preset 4
Clear
Preset
Rename
Preset
Save
Current
Config
Copy
From
Copy To
Recall
On
Powerup