User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 0 14 Wohler Te c h no l o g i e s, Inc. All rights re se r ved..
47
Ch apt er 3 The “How Do I...” Chapter
Frequently As ked Q uestions
Figure 3–18 Hot Key Configuration Menu
1. Turn the control associated with the hot key you want to be used
to quickly recall a preset that the long bar (not the control label) is
highlighted. Press the control until the Recall Preset or the
Status/Metadata/Preset function displays.
2. Turn the control to the number of the preset you wish the control
to recall. You can also set it to Selectable .
3. Now, on the Main Screen , that same control will recall a preset.
How Do I Set Up a SuperPair to Monitor Intercom or
Other Sources?
A SuperPair is a 9th audio input pair that you can monitor along with
the normally monitored audio channels. It can be any input pair. This
special pair can be heard in the speakers or outputs, but is not metered
on the Main Screen . It is useful if you need to hear production
intercom audio (or any other audio) along with the monitored audio.
If you need a front panel volume control to adjust the SuperPair, please
refer to How Do I Set Up a SuperPair Volume Control? on page 48.
This setup is done in the Monitor Mixer Configuration Menu :
Hot Key 9 - 16 Configuration Menu
Save / ExitHelp Cancel
Off
1 2 3 4 5 6 7 8
Selectable
Dolby Zoom
1 3 5 7 9 11 13 15
2 4 6 8 10 12 14 16
AES Out (4) Trim
AES Mic Channe...29
Recall Preset
Press for Stat/Meta
Status/Metadata
Off
Dolby
Zoom
Key 7
Trim
Key 1
Rec 1
Key 5
Stat
Mdata
Downmix
Dnmix
Key 8
SDI Feed from Den...24
Status/Metadata/Preset
Data
Pre
Key 2
LtRt LoRo
Auto
Mode
Automation On-Off
Configuration Selection
Menu
Main Screen
Menu
Configure
Monitor Mixer
Monitor Mixer
Configuration Menu