User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 014 Wo h l e r Te c h n o l o g ies , In c. A l l r ights re se rve d.
52
Chap ter 3 T he “H ow Do I .. .” Chap te r
Frequently Aske d Q ue stions
Figure 3–22 Hot Key Configuration Menu
1. Turn the control associated with the hot key you want the
downmix to be on so that the long bar (not the control label) is
highlighted. Press the control until the purple AES or Analog
Output Trim function displays. If there are multiple output cards,
note that the card slot number is shown in parenthesis.
2. Turn the control to each of the 16 channels shown and press to
either include that channel in this control's adjustment or not.
Although you can set the control to adjust multiple channels, you
cannot set two different controls to adjust the same channel. If a
channel is already controlled by another hot key, its selection is
shown in gray.
How do I Show Mixer Output Levels on the Level
Meters?
If you have not done so already, you first need to set up a free mix in
the output card. Please refer to How Do I Mix Any Input(s) to Any
Output(s)? on page 50 and set up the needed output mix.
To show mixer output levels, certain configurations must be avoided so
that potential internal feedback loops will not exist within the digital
mixer. Output levels cannot be displayed if:
1. The monitor mix output pair appears as one of the inputs to the
output mixer, or
2. The output mixer is in Follow Monitor mode.
Hot Key 9 - 16 Configuration Menu
Save / ExitHelp Cancel
Off
1 2 3 4 5 6 7 8
Selectable
Dolby Zoom
1 3 5 7 9 11 13 15
2 4 6 8 10 12 14 16
AES Out (4) Trim
AES Mic Channe...29
Recall Preset
Press for Stat/Meta
Status/Metadata
Off
Dolby
Zoom
Key 7
Trim
Key 1
Rec 1
Key 5
Stat
Mdata
Downmix
Dnmix
Key 8
SDI Feed from Den...24
Status/Metadata/Preset
Data
Pre
Key 2
LtRt LoRo
Auto
Mode
Automation On-Off