User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 0 14 Wohler Te c h no l o g i e s, Inc. All rights re se r ved..
53
Ch apt er 3 The “How Do I...” Chapter
Frequently As ked Q uestions
3. Analog I/O Cards with the TOSLINK option will not allow the
analog outputs to be routed back to the monitor mixer to be
metered. The internal pathways used for this feature are also used
by the TOSLINK Card.
Output free mix channel pairs will appear as sources in the Monitor
Mixer Configuration Menu :
Figure 3–23 Monitor Mixer Configuration Menu
1. Use the Mixer Channel Select to scroll to the channel pair where
you want the output signals to be displayed.
2. Use the Source Pair Select control to select the output pair to be
metered.
3. Now is also a good time to use the Channel Function control to
designate the function of the channels in that pair.
4. Press the Set Clusters control to proceed to the Cluster
Configuration Screen . On that screen, use the Select Cluster
control, following by the Edit Cluster Label control to name the
output meter pair.
Configuration Selection
Menu
Main Screen
Menu
Configure
Monitor Mixer
Monitor Mixer
Configuration Menu
Monitor Mixer Configuration Menu
Save / ExitHelp Cancel
Chan 1 Chan 2 Chan 3 Chan 4
Slot 2 SDI-3G In
Pair 4
Slot 1 AES In
Pair 1
+0 +0 +0+0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay to Speakers = 170 mS
Audio
Delay
Dolby 5.1
Speaker
Mute:
Off
L Front R Front Center LFE
Channel
Func
Mixer
Channel
Select
Set
Clusters