User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 014 Wo h l e r Te c h n o l o g ies , In c. A l l r ights re se rve d.
54
Chap ter 3 T he “H ow Do I .. .” Chap te r
Frequently Aske d Q ue stions
How Do I Configure the Audio Inputs or Outputs?
If you need to initially set up the audio inputs so that they can be
monitored, refer to I. Configure the Monitor Mixer on page 5.
If you need to configure an input or output card in one of the slots, go
to the Audio Processor Card Menu :
Figure 3–24 Audio Processor Card Menu
1. Press the control associated with the slot that contains the card you
want to adjust (Figure 3–24 above). You may also configure the
optional Dolby decoder card.
2. Depending upon the type of card, there will be more or fewer
options that can be adjusted.
How Do I Set the Clock Source?
All inputs to the AMP2-16V must be synchronized to the same clock.
By default, the system will automatically select a logical clock source,
such as the 3G/HD/SD-SDI card in the lowest numbered slot.
Configuration Selection
Menu
Main Screen
Menu
Audio
Processors
Audio Processor Card Menu
Audio Processor Card Menu
Save / ExitHelp Exit
3G SDI I/O Card
Configuration
Slot 1
No Card Installed
Analog I/O Card
Configuration
AES Output Card
Configuration
AES Input Card
Configuration
Slot 5
Slot 3
Slot 4
Dolby Card
Configuration
Dolby
Slot 2
AES/SDI
Outputs
Pass Dolby
Block Dolby