User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide

Chap ter 4 Features and Screens

Intern al Rout er a nd Mixer

Internal Router and Mixer

The wide variety of input and output possibilities offered by the

AMP2-16V is a product of the flexible internal digital audio routing

system depicted in the diagram in Figure 4–9 on page 72.

As a factory default, the AMP2-16V will be configured to produce

audio in the self-contained speakers from the card in the monitor's

lowest numbered occupied slot (typically Slot 1). However, you can

configure the monitor to produce audio in the front speakers from any

available input sources. Refer to I. Configure the Monitor Mixer on

page 5 for details.

Note that you can set up multiple audio paths. For example, while

monitoring de-embedded SDI audio channels through the speakers,

you may independently decode Dolby channels from an AES stream,

convert them to analog, and output them. Setups like this can be stored

as presets and called up at will.

Any monitored input can be routed to any AES or analog output pairs.

These powerful features will allow de-embedded, Dolby decoded, or

other digital or analog audio to be used by other products. The audio

that is output doesn't necessarily need to be monitored by the meters or

speakers.