Installation Guide

W415-4094 / 06.10.22
25
EN
5.0 FAQs
How to pair the thermostat with Indoor & Outdoor Sensors?
1. Click the “+” button at the top-right corner of the interface in
“Menu” -> “Sensors” on the thermostat and tap “Next”.
2. Remove the rear cover of the sensor.
3. Press and hold the button on the back of the sensor until
the indicator on the front of the sensor flashes red.
4. Wait for sensors to pair automatically. When the pairing is
successful, the sensor flashes green 3 times.
5. For Outdoor Sensors only: Place the temperature probe
of the sensor outdoors while leaving the main body of the
sensor indoors. Make sure the sensor is within 10 meters of
the thermostat.
You can set the indoor remote sensor as the main sensor or to
only participate in the calculation of the average temperature.
(Only one sensor can be set as the main sensor at a time). With
multiple indoor remote sensors, if one of them is set as the
main sensor, the other indoor remote sensors and the built-in
sensor will continue to participate, according to the different
participation periods set. The thermostat will calculate the
average temperature of all the sensors in the occupied state as
a reference. If there is no one in the room where the sensor is
located, that sensor will not participate in the calculation.