riser installation

Contents

DUAL FUEL RANGE RISER

1 Panel, front

1 Panel, back

2 Supports, side

1 Support, center

21 Screws, #8 x

/2"

1 Shelf, stainless steel (20" tall riser only)

5 Screws, shoulder (for shelf installation only)

1 Instructions

Dual Fuel Range Riser Installation

wolfappliance.com 800.222.7820

Riser Installation

INSTALL SIDE SUPPORTS

Place front panel on a protected work surface front side

down and remove the protective material from the back

of the assembly. Limit the amount of material removed

to ensure the stainless steel is protected throughout the

assembly process. Insert side supports into riser assembly

and secure using two #8 x

/2" screws per side. 48" wide

risers have a unique bracket that must be placed on the left

of the riser. Refer to the illustrations below.

page 1 of 2

Left side support.

Left side support (48" only).

Right side support.

PAGE 1
Dual Fuel Range Riser Installation wolfappliance.com Contents 800.222.7820 Riser Installation DUAL FUEL RANGE RISER INSTALL SIDE SUPPORTS 1 Panel, front 1 Panel, back 2 Supports, side 1 Support, center 21 Screws, #8 x 1/2" 1 Shelf, stainless steel (20" tall riser only) 5 Screws, shoulder (for shelf installation only) 1 Instructions Place front panel on a protected work surface front side down and remove the protective material from the back of the assembly.
PAGE 2
wolfappliance.com 800.222.7820 Riser Installation INSTALL CENTER SUPPORT INSTALL RISER Place center support bracket on a protected work surface then place the riser back panel on the center support and install one #8 x 1/2" screw in the lower hole. Refer to the illustration below. Remove the island trim from the range by extracting the screws along the top and both sides. Place the new riser on the range.