installation instructions

INSTALLATION

NOTICE: Depending on the model, additional bezels may

be included with this kit but not utilized.

1 Remove knobs (if installed) then remove existing bezels

by extracting two screws from each bezel. Refer to the

illustration below.

2 Remove new bezels from packaging and discard

packaging material then install new bezels with existing

screws.

3 Reinstall knobs. Using the chart as reference, identify

the icon etched next to each bezel to determine the cor-

rect placement. For dual fuel ranges, refer to the illustra-

tion below for oven selector bezels placement.

4 If any of the knobs "stick" when pressed, remove the

knob and slightly loosen the two bezel screws. Refer to

the illustration below. Once the proper alignment has

been achieved, tighten screws and reinstall knob.

CAUTION

Do not place bezels in dishwasher. Do not soak or use

abrasive cleaners. To clean, wipe with a damp cloth and

mild detergent and water; rinse and dry.

Icon Text On Knob

Hi-Low and Simmer Hi-Low

100°F to 450°F

Off and Hi

ICON

BEZEL

SCREW

Bezel placement.

Oven selector knob.

(dual fuel range only)

NYLINER

OVEN SELECTOR KNOB

Bezel Installation Instructions

wolfappliance.com 800.222.7820

page 1 of 1

9006431 REV-A 07/2015