riser installation

INSTALL RISER
Remove the back panel and island trim from the range by
extracting the screws along the top and both sides. Place
the new riser on the range. For ranges with a griddle, verify
the front of the riser is positioned between the griddle vent
and griddle support. With the riser properly positioned,
secure using three screws per side. For 48" (1219) and
60" (1524) risers, insert one screw into the center support
bracket. Once riser is secure, reinstall back panel using
existing screws. Refer to the illustrations below.
Riser Installation
INSTALL SIDE SUPPORTS
Place riser assembly on a protected work surface, front
side down and remove the protective material from the
back of the assembly. Limit the amount of material removed
to ensure the stainless steel is protected throughout the
assembly process. Install the side support brackets using
two screws per side, three for 20" (508) tall riser. Refer to
the illustration below.
INSTALL SHELF—20" (508) TALL RISER ONLY
Remove all remaining protective material from the riser.
Install two shoulder screws per side. For the 60" (1524) riser,
install one screw in the center. Align the keyhole slots on
the shelf with the shoulder screws and lower the shelf into
position. Refer to the illustration below.
Attach side supports. Remove trim and panel.
BACK PANEL
ISLAND TRIM
Gas Range Riser Installation
Contents
Gas Range Riser
1 Assembly, stainless steel riser
2 Supports, side
12 Screws, sheet metal
1 Shelf, stainless steel (20" tall riser only)
6 Screws, shoulder (for shelf installation only)
1 Instructions
Page 1 of 1821270 REV-B 10/2012
GRIDDLE
VENT
GRIDDLE
SUPPORT
RISER FRONT
Range with griddle. Insert riser supports.
CENTER
SUPPORT BRACKET
Attach shelf.
SHELF
SHOULDER
SCREWS
KEYHOLE
SLOTS
wolfappliance.com 800.222.7820