Design Guide
wolfappliance.com | 137
OUTDOOR GRILLS | MODULES
Planning Information
For portable applications, Wolf grill carts are designed
specically to t grill models OG30, OG36, and OG42 and
the side burner. Model OG54 is designed for built-in appli-
cations only.
For built-in applications, Wolf outdoor grills and the burner
module are designed for easy placement into a built-in
enclosure. For outdoor grills, installation in a combustible
enclosure requires an insulating liner. For the burner module,
an insulating liner is not required. The enclosure should be
built according to specications for your specic installa-
tion on the following pages. If the burner module is installed
next to an outdoor grill, a minimum of 12"
(305) is required
between the units on the rotisserie motor side and 2"
(51) on
the opposite side. A rotisserie side conversion kit is avail-
able from an authorized Wolf dealer.
Model BM13 does not include a tank retention system and
cannot be connected to a portable LP tank.
Optional stainless steel accessory doors and drawers are
available for built-in applications. Refer to pages 141–145.
Grill carts, insulating liners, and stainless steel doors and
drawers are avail able through an authorized Wolf dealer. For
local dealer information, visit the nd a showroom section of
our website, wolfappliance.com.
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical codes.
The electrical outlet must be located within reach of the
power cord. A separate circuit servicing only this appli-
ance is required. A ground fault circuit interrupter (GFCI) is
required to reduce the risk of electrical shock.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 120 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type, GFCI
Power Cord 6'
(1.8 m)