Installation Guide

817993
E-Series / Convection Microwave Trim Kit
818126 / Rev A / November, 2010
Page 2 of 2
Step 2 (Refer to Figure 4):
A. Place oven adjacent to wall or cabinet opening
and plug power cord into electrical outlet.
B. Carefully guide complete assembly between bot-
tom cleats and push assembly back.
NOTE: Avoid pinching power cord between oven
and back wall of cabinet opening.
C. Secure bottom duct assembly using two #8-
15x1/2'' screws.
D. Attach frame assembly directly to cabinet opening,
using four #6-18x1'' wood screws.
NOTE: Always pre-drill a pilot hole before
installing screws to avoid damage to cabinet or
trim kit hardware.
E. Adhere decorative trim panels to side brackets, so
they are tight to side and bottom of frame assem-
bly (See Figure 5).
NOTE: The pieces of foam tape are to be used if
gaps appear between the frame and the
microwave perimeter. If gaps are present, remove
the trim and adhere the foam tape to the
microwave where needed.
Frame
Assembly
Top Duct
Figure 4. Microwave Install in Cabinet Opening
Bottom
Duct
Figure 5. Decorative Trim / Unframed Assembly
Large Glass
Decorative Trim
NOTE: Once
installed, trim will
sit tight to side
and bottom of
frame assembly.