Design Guide
92 | Wolf Customer Care 800.222.7820
COMBINATION INSTALLATIONS
IMPORTANT NOTE: If a product is installed next to the
coee system, a horizontal kit must be specified. For all
other configurations, a vertical kit must be specified.
To install a coee system above a cup warming drawer,
one opening for both units must be specified. To achieve
the minimum reveal between the units, place the coee
system support rails on top of the cup warming drawer,
then secure the rails to the sides of the cabinet. Any mate-
rial between the units will increase the horizontal reveal
between the two products.
Planning Information
The coee system can be installed in a standard or flush
inset application. Trim kits are available for vertical, single
and horizontal configurations. All 30" trim options are
based on model EC24/B. There are no trim options for
model EC24/S.
The sides of the cabinetry opening must be adequate to
support installation of the mounting slides. Refer to the
illustration below.
Finish the edges of the opening. They may be visible when
the unit is slid forward.
For standard installations, the face trim will overlap stiles
and rails. Refer to the chart below.
For flush inset installations, a minimum ⁄"
(3) reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
BASE SUPPORT MIN
Coee System 100 lb (45 kg)
TRIM OVERLAP 24" MODEL 30" TRIM
Top ⁄" (5) ⁄" (5)
Bottom 0" (0) 0" (0)
Sides ⁄" (18) 3⁄" (98)
14"
(356)
10"
(254)
3
/4" (19)
TYPICAL
Side support
Coffee System