Installation Guide

10 | Wolf Customer Care 800.222.7820
Cooktop Installation
Remove the cooktop and components from the shipping
package and recycle packing materials.
1 Lower the cooktop into the countertop cutout. Center
the cooktop in the opening with the front edge aligned
parallel to the front edge of the countertop. Using a
pencil, outline the rear edge of the cooktop on the
countertop. Remove the cooktop.
2 Apply the foam strip to the perimeter of the countertop
opening. Refer to the illustration below. Do not seal the
cooktop to the countertop.
3 Insert the cooktop into the opening. Verify the cooktop
is aligned with the front edge of the countertop.
4 Attach the provided brackets to the bottom of the unit.
Insert the 3⁄"
(89) clamping screws into the brack-
ets. Use a screwdriver to tighten the clamping screws
against the bottom of the countertop. Do not over-
tighten screws. Refer to the illustration below.
FOAM STRIP
COUNTERTOP
BRACKET
CLAMPING
SCREW
Cooktop installation
Installation
Troubleshooting
IMPORTANT NOTE: If the cooktop does not operate prop-
erly, follow these troubleshooting steps:
• Verify electrical power is supplied to the cooktop.
• If the cooktop does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
cooktop. Wolf is not responsible for service required to
correct a faulty installation.