User manual

15
WOLF ELECTRIC COOKTOP USE & CARE
COOKTOP OPERATION
SINGLE ELEMENT AND INNER ZONE
To turn on a heating element, touch the
touch pad that corresponds to the
element you wish to use. The power bar
indicator graph will begin to blink and show
a half-power status.
Touch one of the following symbols or touch
pads of the element control while the power
bar indicator graph is still blinking:
Touch to set the element at the
highest heat setting.
Touch the ”
+ ” or ” – ” symbol to set the heat
setting at half-power output.
Touch or to set the element at
the lowest heat setting.
To change the heat setting:
Touch the ” + ” or ” – ” symbol to change the
heat setting incrementally up or down.
Touch to set the element at the
highest heat setting.
Touch or to set the element at
the lowest heat setting.
Touch to turn the element off.
IMPORTANT NOTE: To quickly turn off all
heating elements, use the universal
touch pad located in the lower right area of the
control panel. Refer to the illustration below.
DUAL-ZONE ELEMENT
To turn on a dual-zone heating element,
touch the touch pad of the control that
corresponds with the dual-zone element. Refer
to the illustration on the following page.
Set the heat setting for the inner element
zone as described previously.
Touch and the outer element zone
will be set to the same heat setting as the
inner zone. A light will remain on under the
touch pad to indicate the outer
element zone has been turned on.
Changing the heat setting to the entire
dual-zone element is the same as for a
single element.
Touch again to turn off the outer
element zone. The light under the
touch pad will go out.
The illustrations below show the control panel
of Model ICBCT36E.
Heat settingsHeating element activation Universal OFF touch pad
Universal OFF
touch pad
SIM touch
pad
HIGH
touch pad
OFF ON
touch pad
”+” and ”–”
symbols