Design Guide
88 | Wolf Customer Care 800.222.7820
Coffee System
COMBINATION INSTALLATIONS
If a Coee System is installed above a Cup Warming
Drawer, specify one opening for both units. To achieve
the minimum reveal between the units, place the Coee
System support rails on top of the Cup Warming Drawer,
then secure the rails to the sides of the cabinet. Any
material between the units will increase the horizontal
reveal between the two products.
Planning Information
The Coee System can be installed in a standard or flush
inset application. The sides of the cabinet opening must
be adequate to support installation of the mounting slides.
Refer to the illustration below.
Finish the edges of the opening.
For standard installations, the face trim overlaps stiles and
rails. Refer to the chart below.
For flush inset installations, a minimum ⁄"
(3) reveal is
required on all sides. Each corner of the opening must be
exactly 90° to maintain consistent reveals.
INSTALLATION REQUIREMENTS
Minimum Base Support 100 lb (45 kg)
TRIM OVERLAP 24" MODEL 30" MODEL
Top ⁄" (5) ⁄" (5)
Bottom 0" (0) 0" (0)
Sides ⁄" (18) 3⁄" (98)
14"
(356)
3"
(
76
)
3
/4" (19)
TYPICAL
Slide support