Owners Manual

4
|
Wolf Customer Care 800.222.7820
SAFETY PRECAUTIONS
GENERAL SAFETY PRECAUTIONS
Sufcient air is needed for proper combustion and
exhausting of gases through the ue (chimney) of
fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturer’s
guideline and safety standards such as those pub-
lished by the National Fire Protection Association
(NFPA), the American Society for Heating, Refrig-
eration and Air Conditioning Engineers (ASHRAE)
and the local code authorities.
Do not operate any fan with a damaged cord or
plug. Discard fan or return to an authorized service
facility for examination and/or repair.
This appliance must be grounded.
CAUTION
For general ventilating use only. Do not use to
exhaust hazardous or explosive materials and
vapors.
Ducted fans must always be vented to the
outdoors.
To reduce the risk of re, use only steel ductwork.
Do not install this downdraft with the activating
switch directly behind a burner or element. The
minimum distance between the switch and edge of
the burner should be 4" (102).
Do not wear loose-tting or hanging clothing when
operating this appliance. It may be ignited by
burners or elements on the cooktop.
Children should not be left alone or unattended in
the area where this appliance is in use.
CAUTION
To reduce the risk of re and properly exhaust air,
be certain to duct air outside. Do not vent exhaust
air into spaces within walls or ceilings or into
attics, crawl spaces or garages.
IMPORTANT INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Read this use & care guide carefully before using
your new downdraft ventilation to reduce the risk
of re, electric shock or injury to persons.
Ensure proper installation and servicing. This
appliance must be properly installed and grounded
by a qualied technician.
Warranty service must be performed by Wolf
Factory Certied Service.
Installation work and electrical wiring must be done
by qualied person(s) in accordance with all appli-
cable codes and standards, including re-rated
construction codes and standards.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
a)
Use this unit only in the manner intended by
the manufacturer. If you have questions, con-
tact the manufacturer.
b) Before servicing or cleaning unit, unplug the
appliance or switch power off at service panel
and lock the service disconnecting means
to prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten a
prominent warning device, such as a tag, to
the service panel.