Use and Care Guide

wolfappliance.com | 7
DOWNDRAFT OPERATION
Downdraft Operation
CONTROL MODULE
1 To activate the downdraft, press the UP/DOWN button.
The downdraft chimney will elevate and the blower will
turn on automatically to low speed. Refer to the illustra-
tion below.
2 To adjust the blower speed, press the HIGH+, MEDIUM
or LOW button. The corresponding LED will illuminate to
indicate blower setting.
3 To initiate boost mode, press and hold the HIGH+ button
for 5 seconds. Boost increases airow by approximately
20% more than high, but is limited to 10 minutes. After
10 minutes, the blower will automatically transition to
high.
4 To deactivate the blower, press the button that corre-
sponds with the illuminated LED indicator or press
UP/DOWN.
DELAY FEATURE
The delay feature continues blower operation for approxi-
mately ve minutes after use, then automatically turns off.
If the blower was operating on high or medium speed,
the blower will transition to the next lowest setting for ve
minutes before turning off. The chimney will stay up until the
UP/DOWN button is pressed.
Control module.
FILTER INDICATOR
After approximately 30 hours of operation, the FILTER LED
will illuminate to indicate lters need to be cleaned. Refer to
care recommendations on page 9.
To reset the lter indicator, press the FILTER button. Refer to
the illustration below.