Design Guide

wolfappliance.com | 47
Planning Information
CONVECTION / STANDARD MICROWAVES
Convection and Standard Microwave Ovens can be
installed in a standard or flush inset application using
accessory trim to match Wolf ovens. Trim kits are avail able
through an authorized Wolf dealer. For local dealer infor-
mation, visit the find a showroom section of our website,
wolfappliance.com.
For standard installations, the face trim will overlap stiles
and rails. Refer to the chart below.
Convection and Standard Microwave Ovens can also be
used freestanding. For freestanding applications, a mini-
mum 2"
(51) space is required at the top, rear, and sides of
the microwave oven for air circulation.
INSTALLATION REQUIREMENTS
BASE SUPPORT MIN
Convection Microwave 125 lb (57 kg)
Standard Microwave 125 lb (57 kg)
27" E SERIES TRIM OVERLAP CONVECTION STANDARD
Top ⁄" (6) ⁄" (14)
Bottom ⁄" (19) ⁄" (17)
Sides ⁄" (21) ⁄" (21)
30" M/E SERIES TRIM OVERLAP CONVECTION STANDARD
Top ⁄" (6) ⁄" (14)
Bottom ⁄" (19) ⁄" (17)
Sides 1⁄" (30) 1⁄" (30)
Electrical Requirements
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustrations on
the following pages. The receptacle may also be located
in an adjacent cabinet within reach of the power cord. A
separate circuit servicing only this appliance is required. A
ground fault circuit interrupter (GFCI) is not recommended
and may cause interruption of operation. Refer to the illus-
tration below for minimum power cord plug clearance.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 120 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type
Power Cord 4' (1.2 m)
3"
(76)
MINIMUM CORD
CLEARANCE
Power cord clearance
Microwave Ovens