Design Guide

58 | Wolf Customer Care 800.222.7820
Planning Information
The Warming Drawer must be installed with a Wolf drawer
front, avail able through an authorized Wolf dealer. For
local dealer information, visit the find a showroom section
of our website, wolfappliance.com. Specific installation
instructions are included with the drawer front.
The Warming Drawer can be installed in a standard or flush
inset application.
For a standard installation, the drawer collar and front
panel sit proud of the cabinet face frame. A recessed
installation requires the cabinetry be recessed by ⁄"
(5)
so the collar is flush with the cabinet face frame but the
drawer front will sit proud. A flush inset installation requires
the drawer collar and front panel be recessed to be flush
with surrounding cabinetry. Refer to illustrations on the
following pages for minimum cabinet dimensions for your
specific installation.
Finish the edges of the opening. They may be visible when
the drawer is open.
For standard installations, the face trim will overlap stiles
and rails. Refer to the chart below.
For flush inset installations, a minimum ⁄"
(3) reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
Model WWD30O is CSA approved for outdoor installations.
INSTALLATION REQUIREMENTS
Min Base Support 200 lb (90 kg)
Trim Overlap (top, bottom, sides) ⁄" (16)
Warming Drawers