Dual Fuel Range Use and Care Guide
wolfappliance.com | 25
Troubleshooting
Troubleshooting
OPERATION
Range does not operate.
• Verify power is on.
• Verify electrical power to the range and home circuit
breaker is on.
• The oven automatically turns o after 12 hours of con-
tinual use, except in Dehydration or Sabbath mode.
Clock turns o.
• The unit is in standby power mode. Refer to page 10.
OVEN
Oven temperature issue.
• Contact Wolf Customer Care at 800-222-7820.
No oven control knob display.
• Remove and reinstall the knob. Turn the circuit breaker
o for 20 seconds, then turn it back on.
No response from control panel.
• Turn the circuit breaker o for 20 seconds, then turn it
back on.
“SAb” displayed on the oven control knob.
• Unit is in Sabbath mode (
is displayed on the control
panel), refer to page 17.
Error displayed on the control panel.
• Contact Wolf Factory Certified Service.
Oven “pops” or “bangs” during preheat or cool down.
• Normal with new oven cavity expansion and contrac-
tion.
• Run a Clean cycle. If it persists, contact Wolf Customer
Care at 800-222-7820.
Oven door is locked.
• The oven door locks and remains locked until the Clean
cycle has ended and the oven temperature is below
550°F
(290°C).
RANGE SURFACE
Erratic flame, poor ignition, or no ignition.
• Verify the burner caps are positioned properly.
• Clean the burner and igniter properly.
• If water spilled over recently, let the area dry com-
pletely. Use a hair dryer, if desired.
• Push in the knob, then release. Verify the knob springs
back.