GRange IG

8 | Wolf Customer Care 800.222.7820

Preparation

Before moving the range, protect any ﬁnished ﬂooring and

secure oven door(s) closed to prevent damage.

To lighten the load or to ﬁt through a door way, the oven

door(s) can be removed. Remove only if necessary. Do not

remove the griddle or any other component. Door removal

should be done only by a certiﬁed installer or service tech-

nician.

For removal, a hinge pin will be inserted into the appropri-

ate hinge shown in the illustrations below. The pin(s) are

located inside the oven door. For single oven ranges, the

hinge pin must be inserted in the right hinge. For double

oven ranges, the pins must be placed in the outer two

hinges.

CAUTION

Failure to insert the hinge pin in the appropriate

hinge arm will cause damage to the range.

Installation

OVEN DOOR REMOVAL

1 Insert the hinge pin into the appropriate hinge.

2 Remove the lower kickplate assembly to access the

lower hinge retainer mounting screws.

3 Open the oven door and remove both upper and lower

hinge retainer mounting screws. The oven gasket may

have to be moved slightly to access the bottom screws.

4 Move the hinge retainer plate forward slightly. The

hinge retainer plate will remain on the door hinge after

the mounting screws have been removed.

5 Carefully close the oven door to approximately 60°,

then lift the door up and out. A slight rocking motion

may be required for removal.

SPRING HINGES

SPRING HINGE

SPRING HINGES

SPRING HINGE

Single oven ranges

Double oven ranges

KICKPLATE

UPPER

MOUNTING

SCREW

HINGE

RETAINER

PLATE

HINGE

Oven door removal