Use and Care Guide

wolfappliance.com | 17
SURFACE OPERATION
Surface Operation
POWER LEVEL INDICATOR
When an element is activated, a power level indicator illumi-
nates above the corresponding control indicating the level
of heat. The lowest heat is represented by the small ame,
varying levels of heat by additional indicators (dots), and the
highest heat by all indicators including the large ame. Refer
to the chart and illustration below.
SETTING POWER LEVEL USES
Melt 1 (small ame)
indicator
Melting butter and holding
chocolate and sauces.
Simmer 2–6 indicators Simmering sauces and
steaming rice.
Medium 6–7 indicators Making French toast and pan-
cakes and heating milk, cream
sauces, soups, and gravies.
Medium High 7-8 indicators Sauteing, browning, and frying.
High 8–10 (large ame)
indicators
Boiling water, searing meat,
and canning.
Power level indicator.
SINGLE ELEMENT | INNER ZONE
Setting controls:
1 To activate an induction element, touch ON/OFF for the
desired single element on the control panel. The power
level indicator ashes, and all indicators for that zone
ash. Refer to the illustration below.
2 To complete the activation, touch HI for highest heat,
SIM (MLT) for lowest heat, BOOST to activate boost
mode, or the desired power level indicator.
3 To change the heat setting while the element is on, touch
or slide to the desired power level.
4 To turn the element off, touch ON/OFF.
IMPORTANT NOTE: If no cookware or incompatible cook-
ware is placed on an induction element after activation, the
control ashes for 30 seconds, then the element turns off
automatically.
Element activation.
ON/OFF