Use and care guide

wolfappliance.com | 17
SURFACE OPERATION
Surface Operation
POWER LEVEL INDICATOR
When an element is activated, a power level indicator will
illuminate above the corresponding control indicating the
level of heat. The lowest heat is represented by the small
ame, varying levels of heat by additional indicators (dots),
and the highest heat by all indicators including the large
ame. Refer to the chart and illustration below.
SETTING POWER LEVEL USES
Melt 1 (small ame)
indicator
Melting butter, holding
chocolate and sauces.
Simmer 2–6 indicators Simmering sauces and
steaming rice.
Medium 6–7 indicators Making French toast and
pancakes, heating milk, cream
sauces, soups and gravies.
Medium High 7-8 indicators Sauteing, browning and frying.
High 8–10 (large ame)
indicators
Boiling water, searing meat and
canning.
Power level indicator.
SINGLE ELEMENT | INNER ZONE
Setting controls:
1 To activate a induction element, touch ON/OFF for the
desired single element on the control panel. Power level
indicator will ash and all indicators for that zone will
ash. Refer to the illustration below.
2 To complete the activation, touch HI for highest heat,
SIM (MLT) for lowest heat, BOOST to activate boost
mode, or touch desired power level indicator.
3 To change heat setting while the element is on, touch or
slide to desired power level.
4 To turn element off, touch ON/OFF.
IMPORTANT NOTE: If no cookware or an incompatible pan
is placed on an induction element after activation, the con-
trol will ash for 30 seconds, then the element will turn off
automatically.
Element activation.
ON/OFF