P R O V E N T I L AT I O N H O O D L I N E R S I NSTALLATION I NSTRUCTIONS
C O N TA C T I N F O R M AT I O N Wolf Customer Service: 800-332-9513 Website: wolfappliance.com As you follow these instructions, you will notice WARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Wolf equipment. There are two types of potential hazards that may occur during installation. signals a situation where minor injury or product damage may occur if you do not follow instructions.
W O L F P R O V E N T I L AT I O N H O O D L I N E R S I N S TA L L AT I O N R E Q U I R E M E N T S IMPORTANT NOTE: This installation must be completed by a qualified installer or Wolf authorized service center technician. Installer: Please read the entire Installation Instructions prior to installation. Save these instructions for the local inspector’s reference, then leave them with the homeowner.
W O L F P R O V E N T I L AT I O N H O O D L I N E R S I N S TA L L AT I O N R E Q U I R E M E N T S I N S TA L L AT I O N C O N S I D E R AT I O N S L I S T O F M AT E R I A L S IMPORTANT NOTE: Wolf Pro ventilation hood liners are recommended for use with all Wolf cooking appliances and are available to accommodate 36" (914), 42" (1067), 48" (1219), 54" (1372) and 60" (1524) wide hoods. The following is a list of materials shipped with the Wolf Pro ventilation hood liner.
I N S TA L L AT I O N I N S T R U C T I O N S OV E R A L L D I M E N S I O N S P RO H O O D L I N E R S TOP WIDTH Overall Widths 34 3/8" (873), 40 3/8" (1026), 46 3/8" (1178), 52 3/8" (1330) and 58 3/8" (1483) Overall Height 12" (305) Overall Depth 22 1/2" (572) Shipping Weight (shell only) SUBTRACT 6" (152) FROM OVERALL WIDTH 3" 22 3/4" 3" (76) (578) (76) 12" (305) 12" (305) OVERALL HEIGHT 44–65 lbs (20–29 kg) Dimensions may vary to –+ 1/8" (3).
W O L F P R O V E N T I L AT I O N H O O D L I N E R S I N S TA L L AT I O N S P E C I F I C A T I O N S D E C O R AT I V E H O O D S The illustration and chart below provide dimensions critical for proper installation of the Pro hood liner. A decorative hood can be created out of wood, plaster, tile or metal. The shape of the decorative hood is not critical. The only place where the hood liner and outside cover must meet is at the bottom edge of the liner.
I N S TA L L AT I O N I N S T R U C T I O N S I N S TA L L D U C T WO R K To reduce the risk of fire, use only metal ductwork. DUCTWORK INSTALLATION THROUGH ROOF ROOF CAP OR REMOTE BLOWER IMPORTANT NOTE: Wolf recommends that the Pro ventilation hood liner be installed 30" (762) to 36" (914) above the countertop. IMPORTANT NOTE: Consult a qualified HVAC Engineer for specific ducting applications. IMPORTANT NOTE: All Wolf ventilation hood liners must exhaust to the outdoors. Always use metal ducting.
W O L F P R O V E N T I L AT I O N H O O D L I N E R S WA L L P R E P A R A T I O N H O O D L I N E R P R E PA R AT I O N If you are installing LBLOWER-120INT, refer to the internal blower information on page 11 and follow installation instructions provided with the blower. Framing must be tied together and to ceiling joists to provide enough structural strength to support the weight of the hood liner and internal blower, if applicable. The hood liner assembly is shipped with the transition attached.
I N S TA L L AT I O N I N S T R U C T I O N S H O O D L I N E R P R E PA R AT I O N If you are installing an in-line or remote blower, drill a 7/8" (22) hole through the wood framing for the conduit. Refer to the in-line and remote blower information on pages 12–13 and follow installation instructions provided with the blower. IMPORTANT NOTE: Do not run wiring for the remote blower through the ductwork.
W O L F P R O V E N T I L AT I O N H O O D L I N E R S I N S TA L L W I R I N G I M P O R TA N T N OT E You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service. This ventilation hood liner must be properly grounded and should be installed by a qualified electrician in accordance with all applicable national and local electrical codes.
I N S TA L L AT I O N I N S T R U C T I O N S INTERNAL B L OW E R IMPORTANT NOTE: Refer to the installation instructions provided with the internal blower for additional mounting and wiring instructions. IMPORTANT NOTE: Before turning the power on to the ventilation hood liner, make sure the blower is off. IMPORTANT NOTE: Use wire connectors or wire nuts approved by UL or C/UL. L B L O W E R - 1 2 0 I N T I N S TA L L A T I O N Slide the blower mounting tab into the hood liner top plate mounting slot.
W O L F P R O V E N T I L AT I O N H O O D L I N E R S I N - L I N E A N D R E M OT E B L O W E R S B L O W E R I N S TA L L A T I O N IMPORTANT NOTE: Refer to the specific installation instructions provided with each blower for additional mounting instructions. ACCESSORIES Optional accessories are available through your Wolf dealer. To obtain local dealer information, visit the Locator section of our website, wolfappliance.com.
I N S TA L L AT I O N I N S T R U C T I O N S I N - L I N E A N D R E M OT E B L O W E R S Plug the cord assembly into the receptacle located near the center of the hood shell. Use the clips on the interior of the hood to keep excess power cord away from moving parts. BLOWER WIRING IMPORTANT NOTE: Refer to the specific installation instructions provided with each blower for additional wiring instructions.
W O L F P R O V E N T I L AT I O N H O O D L I N E R S I N S TA L L F I LT E R S Remove all packaging material from the filters. ACCESSORIES Optional accessories are available through your Wolf dealer. To obtain local dealer information, visit the Locator section of our website, wolfappliance.com. Install the filters. Orient each filter with lines running vertically. Position the top edge of the filter as shown in the illustration below.
I N S TA L L AT I O N I N S T R U C T I O N S TROUBLES H O OT I N G IMPORTANT NOTE: If the Pro ventilation hood liner does not operate properly, follow these troubleshooting steps: Verify that power is being supplied to the ventilation hood liner. Check electrical connections to ensure that the installation has been completed correctly. Refer to the Troubleshooting Guide in the Wolf Pro Ventilation Hoods Use & Care Information.
W O L F A P P L I A N C E C O M PA N Y, I N C. 810481 2 / 2007 P. O. B OX 4 4 8 4 8 MADISON, WI 53744 800-332-9513 W O L FA P P L I A N C E .