MDraw IG

Troubleshooting
IMPORTANT NOTE: If the drawer microwave oven does not
operate properly, follow these troubleshooting steps:
• Verify electrical power is supplied to the microwave
oven.
• Verify proper electrical connections.
• If the microwave oven does not operate properly, contact
Wolf factory certied service. Do not attempt to repair
the oven. Wolf is not responsible for service required to
correct a faulty installation.
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero,
Sub-Zero & Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks
of Sub-Zero, Inc. All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
wolfappliance.com | 7
INSTALLATION
Preparation
Remove and recycle packing materials. Do not remove the
waveguide cover located on the upper surface of the drawer
interior. Refer to the illustration below.
Install an anti-tip block against the rear cabinet wall. Verify
the screws are adequately secured and do not penetrate
electrical wiring or plumbing.
Installation
1 Turn power off to the electrical outlet.
2 Move the unit near the opening. Plug the power cord into
the grounded outlet.
3 Position the microwave oven in the opening and slide
back until the mounting ange is ush with the face of
the cabinet. Avoid pinching the power cord between the
unit and cabinet wall.
4 Open the drawer. Using the two holes on either side of
the mounting ange as a template, drill pilot holes into
the cabinet using a
1
/16" drill bit.
5 Mount the microwave oven using four screws provided.
Refer to the illustration below.
6 Turn power back on to the electrical outlet.
MOUNTING
FLANGE
Waveguide cover. Mounting.
WAVEGUIDE
COVER