Installation Instructions

wolfappliance.com | 7
Installation
1 Turn power off to the electrical outlet.
2 Move the unit near the opening. Remove and recycle
packing materials.
3 The unit is shipped with two shipping brackets located
on each side, behind the front face. Remove both
brackets, then reinstall screws. Refer to the illustration
below.
4 Plug the power cord into the grounded outlet.
5 Position the microwave oven in the opening and slide
back until the mounting ange is ush with the face of
the cabinet. Avoid pinching the power cord between the
unit and cabinet wall.
6 Open the door. Using the two holes on either side of the
mounting ange as a template, drill pilot holes into the
cabinet using a
1
/16" drill bit.
7 Mount the microwave oven using four screws provided.
Refer to the illustration below.
8 Turn power back on to the electrical outlet.
Troubleshooting
IMPORTANT NOTE: If the drop down door microwave oven
does not operate properly, follow these troubleshooting
steps:
• Verify electrical power is supplied to the microwave
oven.
• Verify proper electrical connections.
• If the microwave oven does not operate properly, contact
Wolf factory certied service. Do not attempt to repair
the oven. Wolf is not responsible for service required to
correct a faulty installation.
INSTALLATION
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero,
Sub-Zero & Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks
of Sub-Zero, Inc. All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
REMOVE
BRACKETS
THEN REINSTALL
SCREWS
MOUNTING
SCREWS
Shipping brackets. Mounting screws.