Internal Blower Install

CONTENTS
1 Assembly, blower
MOUNTING PLATE (SINGLE BLOWER ONLY)
Secure the mounting plate (shipped with the blower) to the
blower with four nuts.
24" AND 27" PRO WALL HOODS
1 For single blowers only, remove the center section
from the hood discharge.
TOP OF
H
OOD
CENTER
SECTION
2 Install each blower using four nuts per blower.
TOP OF
H
OOD
PRO ISLAND, PRO CHIMNEY
, PRO LINER, AND OUTDOOR
HOODS
1 Remove the two nuts from the blower mounting
bracket, then remove the bracket from the hood.
BRACKET
TOP OF
HOOD
2 For single blowers only, remove the center section
from the bracket.
CENTER
SEC
TION
3 Install each blower on the bracket using four nuts per
blower
.
4 Align the tabs on the back of the bracket with the
notches at the back of the discharge, then rotate the
front of the assembly upward and secure the
assembly with the two existing nuts.
Pro Hoods Internal Blower Installation
www.subzero-wolf.com 800.222.7820
10/2021
Page 1 of 1