Installation Guide

wolfappliance.com | 13
LIGHT BULBS
A suction-cup-style light bulb changer is provided with
the hood. To install, use the changer to push the bulb into
the receptacle and rotate counterclockwise one-quarter
turn. Refer to the illustration below.
For 27"
(686) deep wall hoods, install the heat lamp bulbs
(not included). Use R40, 250W bulbs.
WOLF LOGO
To attach the Wolf logo, clean the mounting area with
rubbing alcohol. Remove the paper backing, position the
logo parallel with the bottom of the hood, and press into
place.
Complete the Installation
GREASE CUP, SPACERS, AND FILTERS
IMPORTANT NOTE: Spacers are not included with low-
profile hoods. Grease cups and spacers are not included
with hood liners.
Install the grease cup(s), then install the spacers and filters.
Refer to the illustrations below.
LIGHT BULB
CHANGER
Light bulb
GREASE
CUP
FLANGE
SPACER
Grease cup Spacer
Filters
Installation