Installation Guide

8 | Wolf Customer Care 800.222.7820
Electrical Requirements
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustration
below. A separate circuit servicing only this appliance is
required.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 120 VAC, 60 Hz
Service 15 amp dedicated circuit
E
6"
(152)
5"
(127)
30" (762) TO 36" (914) BOTTOM EDGE TO COUNTERTOP
Electrical location
Rating plate location
RATING PLATE
Hood Preparation
IMPORTANT NOTE: Spacers are not included with low-
profile hoods. Grease cups and spacers are not included
with hood liners.
Remove the filters, spacers, and grease cup(s) prior to
installation.
To remove the filters, press upward, then rotate the bottom
downward. To remove the spacers, slide the spacer toward
the center of the hood slightly. Press upward and rotate
the bottom downward. To remove the grease cup(s), lift
vertically to remove from the rear flange. Refer to the
illustrations below.
SPACER
Filters Spacer
GREASE
CUP
FLANGE
Grease cup
Specifications