Remote Blower Install Guide

MODEL 804701
Page 3
OUTSIDE - ROOF VIEW
OUTSIDE - ROOF VIEW
OUTSIDE - ROOF VIEW
OUTSIDE - WALL VIEW
10 Cover
10 Cover
Screws
Screws
10 Cover
Screws
Drill 6
Mounting
Holes
Bird Screen
Bird Screen
Flashing
Sheet
Flashing
Sheet
Drill 6
Mounting
Holes
Damper
11" dia.
hole
22"
Pilot Hole
(centered between studs)
25"
29½"
29½"
14
11
/ 16 "
11
13
/ 16 "
14
5
/ 8 "
17"
Wall Stud
Wall Stud
11" dia.
hole
20"
1¼" dia. hole
1¼" dia. hole
3 "
REMOVE
SIDING
REMOVE
SIDING
Pilot Hole
(centered between studs)
WALL MOUNT
INSTALLATION
For use with Wolf CTWH30/CTWH36 wall mount, IH4227 island chimney hoods, DD30R/DD36R downdraft ventilators, 18” tall
island/wall hoods & 12” tall liners.
PREPARE THE WALL
WIRE THE VENTILATOR
From inside the wall:
q 1
Drill a PILOT HOLE through the wall, centered between
WALL STUDS.
From outside - on the wall:
q 2
Measure and mark the 25" x 29½" rectangle. Cut and
remove only the siding inside this rectangle.
q 3
Measure and mark the 11" DIAMETER HOLE and the
1¼" DIAMETER HOLE. Cut these holes all the way through
the wall.
BLACK TO BLUE
WHITE
TO
BROWN
120
VAC
LINE
IN
GROUND
TO
GROUNDING
SCREW
INSTALL THE VENTILATOR
q 4
Remove 10
COVER SCREWS
and lift off
ventilator cover.
q 5
Feed the electric
power cable
through the 1¼"
DIAMETER HOLE
and connect cable
to ventilator with a
proper connector
for the type of
cable being used.
q 6
Connect BLACK
TO BLUE, WHITE
TO BROWN, and
GROUND TO
GROUNDING
SCREW.
q 7
Place ventilator on wall so that ventilator's discharge collar
fits into 11" diameter hole.
q 8
Use the 6 screws (provided) to attach the ventilator to the
wall. DRILL 6 MOUNTING HOLES inside the ventilator, as
necessary.
q 9
Seal the screw heads and edges of the flashing sheet with
a good grade of roofing cement.
q 10
Check for free movement of the spring-loaded DAMPER
and re-install ventilator cover. Turn on power and check
operation.