Service manual

Fig. 9
Fig. 10
TEMPERATURE PROBE (WKGD/
WKGDX)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the
RIGHT SIDE PANEL.
NOTE: If right side panel is not accessible, this
component can be serviced by removing the
CONTROL PANEL.
2. Disconnect the probe leads from the solid state
temperature control.
3. Remove the racks and right rack support.
4. Remove the probe guard.
WKG Series Full Size Gas Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
F32700 Rev. B (0315) Page 10 of 74