Service manual

Fig. 42
A. Door assembly parts are now accessible for
inspection and/or replacement if necessary.
6. Reverse procedure to re-assemble the door
assembly parts and check for proper adjustment
as outlined under
DOOR CHAIN ADJUSTMENT
(SIMULATANEOUS DOORS).
ROLLER LATCH ASSEMBLY
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made after 8/12/07 and serial number starting with 54
made after 8/26/07.
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the screws that attach roller latch
assembly to door.
Fig. 43
2. Reverse procedure to install.
DOOR CATCH BALL ASSEMBLY
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made before 8/13/07 and serial number starting with
54 made before 8/27/07.
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the
TOP FRONT COVER.
2. Remove the screws that secure the door catch
assembly.
Fig. 44
3. Reverse procedure to install.
4. Adjust the ball catch as outlined under DOOR
CATCH BALL ADJUSTMENT (INDEPENDENT
DOORS).
DOOR WINDOW
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the screws at the top and bottom of
door.
WKG Series Full Size Gas Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
Page 19 of 74 F32700 Rev. B (0315)