Service manual

Fig. 63
4. Reverse the procedure to install.
DOOR ADJUSTMENT
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Check the doors to make sure they have an equal
gap between them and that the vertical edge of
the door is parallel to the vertical door seal. If the
doors are not positioned in this manner, adjust
the doors as described.
Fig. 64
2. Remove the TOP FRONT COVER.
3. Loosen the screws that secure the upper door
bearings and related hardware, just enough to
allow door movement.
Fig. 65
WKG Series Full Size Gas Convection Ovens - SERVICE PROCEDURES AND ADJUSTMENTS
Page 31 of 74 F32700 Rev. B (0315)