INSTALLATION GUIDE Pro Ventilation Hood Liners
Contents Important Note Wolf Pro Hood Liners. . . . . . . . . . . . . . . . . . . . . . . . . . . 3 To ensure the safe and efficient use of Wolf equipment, please take note of the following types of highlighted information throughout this guide: Installation Considerations . . . . . . . . . . . . . . . . . . . . . . 4 Pro Hood Liner Specifications . . . . . . . . . . . . . . . . . . . 5 Pro Hood Liner Installation . . . . . . . . . . . . . . . . . . . . . .
Wolf Pro Hood Liners 3 wolfappliance.com/specs Pro Hood Liner Installation IMPORTANT NOTE: This installation must be completed by a qualified installer or Wolf factory certified service. Wolf Pro Hood Liner Read this entire installation guide and blower installation instructions prior to installation and save for the local inspector’s reference. The homeowner should keep this installation guide for future reference.
Installation Considerations IMPORTANT INSTRUCTIONS TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY, OBSERVE THE FOLLOWING: • Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. • Two installers are recommended due to the size and weight of the pro hood liner. • Install the pro hood liner only with a blower manufac- tured by Wolf.
Pro Hood Liner Specifications 5 wolfappliance.
Pro Hood Liner Specifications 6 Discharge Specifications Electrical Requirements The illustration below provides dimensions critical for proper installation of the pro hood liner. Dimension A in the illustration will vary with the width of the hood liner. Refer to the chart below. Wolf pro hood liners require a separate, grounded 120 V AC, 60 Hz power supply. The service should have its own 15 amp circuit breaker.
Pro Hood Liner Installation 7 wolfappliance.com/specs Install Ductwork PRO HOOD LINERS To reduce the risk of fire, use only metal ductwork. 10" (254) round, rigid metal duct is recommended for pro hood liners. A straight, short run is most effective and will ensure proper operation. For best results, duct run should not exceed 50' (15 m). For runs exceeding 50' (15 m), a higher CFM blower may be required to maintain proper air flow and performance.
Pro Hood Liner Installation 8 Wall Preparation Hood Liner Preparation Minimum 2" (51) x 4" (102) lumber is required to construct wall framing. Refer to the illustration below for mounting hole locations and a cross-section view of a typical installation. IMPORTANT NOTE: Remove all packaging material from hood liner and damper. Failure to remove material will obstruct airflow and significantly decrease performance.
Pro Hood Liner Installation 9 wolfappliance.com/specs Hood Liner Installation Position the hood liner in the desired location. Insert #10 x 2" (59) screws through the mounting holes on the back plate. Verify the screws engage two wall studs or blocking. Electrical Connection Before making electrical connections, make sure the electrical power is turned off at the service panel. If additional support is required, drill supplementary holes through the back plate and secure with screws.
Pro Hood Liner Installation 10 Complete the Installation Troubleshooting FILTER INSTALLATION IMPORTANT NOTE: If the pro hood liner does not operate properly, follow these troubleshooting steps: To install filters, press upward then rotate bottom outward. The filter vanes should be placed perpendicular to the front of the hood. Refer to the illustration below. To aide in removal, remove center filter first. Gloves should be worn when handling filters.
Service Information 11 Service Information If service is necessary, maintain the quality built into your pro hood liner by contacting Wolf factory certified service. For the name and number of Wolf factory certified service nearest you, check the contact & support section of our website, wolfappliance.com or call Wolf customer care at 800-222-7820.
WOLF APPLIANCE, INC. P. O. BOX 44848 MADISON, WI 53744 821558 REV-B 8/ 2012 WOLFAPPLIANCE.COM 800.222.
