Instructions
~ 76 ~
WARNING!
To reduce the risk of burns, electrocution, fire or injury to persons
1. This appliance is equipped with the environmental-friendly refrigerant
R600a. The refrigerant R600a is inflammable. The components of
the cooling circuit must neither be damaged during transport nor use.
2. If any part of the cooling circuit is damaged, the appliance must not
stand near a fire, naked light or spark-generating devices. Contact
the aftersales service or the shop you purchased the appliance at
immediately.
27
3. If gas is set free at the installation site:
a) Open all windows.
b) Do not unplug the appliance and do not use the control panel or
thermostat.
c) Do not touch the appliance until all the gas has gone.
d) Otherwise sparks can be generated which will ignite the gas.
4. Keep all components of the appliance away from fire and other
sources of ignition when you dispose of or decommission the
appliance.
5. Do not install the appliance near of volatile or combustible materials
(e.g. gas, fuel, alcohol, paints) and in rooms which may have poor air
circulation (e.g. garage).
6. EXPLOSION HAZARD! Do not store any explosive materials or
sprays, which contain flammable propellants, in your appliance.
Explosive mixtures can explode there.
7. While unpacking, the packaging materials (polythene bags,
polystyrene pieces, etc.) should be kept away from children and pets.
CHOKING HAZARD! RISK OF INJURY!
8. Always observe the required minimum distances for proper
ventilation.
9. The appliance must be connected to a suitable drinking water supply
only.
10. The connection of the appliance to the drinking water supply must
be carried out by a qualified professional.
11. Never put your hands in the ice dispenser opening; this can cause
serious injury. RISK OF INJURY!
12. Never touch the blades inside the ice cube maker. RISK OF INJURY!
13. If the ice cubes become discoloured, do not use the ice cubes under
any circumstances but dispose of them. Do not use the ice cube
27
Depending on model: s. page « SERVICE INFORMATION » at the end of this instruction manual.