Instructions

~ 55 ~
9. Install the motor housing (H) properly on the housing of the extractor hood (B)
using the appropriate screws (see step 7): see fig. below.
10. Reinstall the cover of the electronic control box / cable storage (E) properly on
the housing of the extractor hood (B) using the appropriate screws (6 pcs.
ST3*12): see fig. below. Make sure that the cables are not kinked.
A
WORKTOP
B
EXTRACTOR HOOD: HOUSING
C
METAL SUPPORTS
E
COVER OF THE ELECTRONIC CONTROL BOX / CABLE STORAGE
H
MOTOR HOUSING