Use and Care Manual

TECHNICAL DATA
WOLMAN
®
F&P
®
FINISH AND PRESERVATIVE
Form: GDH-18
Rev.: 032113
2
PRODUCT APPLICATION (cont.) .
Apply when outside temperatures are between 50-90°F
(10-38°C) and when no precipitation is expected for 24
hours. Do not apply to wood that is hot to touch or in direct
sunlight to prevent premature evaporation of solvent.
Apply with a natural or synthetic bristle brush, paint pad,
pump sprayer, or airless sprayer. When spraying, work on
a 30-40 square foot area at a time, making sure to back-
brush along the grain any drips, runs, uneven coverage or
surface puddles. Do not over-saturate surface with product
or allow to puddle to prevent shiners, tackiness, excessive
drying time or uneven appearance when dry.
Horizontal Surfaces: Apply one liberal, uniform coat on
decks and other horizontal surfaces. Thoroughly coat all
exposed surfaces until the wood will not absorb additional
product and avoid puddling. A second coat is
recommended only if the wood is highly porous. To test
for this condition, check the penetration rate of the first 30
square foot area coated. If the coating is dry to the touch
in 15 minutes or less, then another light coat may be
applied no later than one hour after the first coat. Only half
the amount is necessary for the second coat.
Vertical Surfaces: Apply two wet-on-wet coats on shake,
shingle or lap siding, roofing, fences and other vertical
surfaces. Do not allow product to dry fully between coats.
Apply a second coat within 6 hours of the first coat.
This product must penetrate the surface to work properly.
Do not apply to a sealed wood surface. Do not use as a
primer coat.
DRY TIME
Because temperatures and humidity fluctuate, allow a
minimum 24-48 hours before using deck, porch, or
outdoor furniture, and 72 hours before returning furniture
to deck/porch surface. Avoid dragging furniture across
surface. On newly treated surfaces, allow 7 days for
coating to cure before washing. CAUTION: BARE WOOD
OR COATED SURFACES CAN BECOME SLIPPERY
WHEN WET. Use caution when walking on wet surfaces.
CLEAN UP
Wipe up wet coating splatters and spills immediately with
mineral spirits. Dried spills can be removed with lacquer
thinner or mineral spirits. Clean up tools and equipment
immediately after use with mineral spirits.