Use and Care Manual

TECHNICAL DATA WLF-03
WOODLIFE
®
COPPERCOAT
™
Form: GDH-417
Rev.: 080714
1
.DESCRIPTION AND USES .
WoodLife
®
CopperCoat
™
Green Wood Preservative is a
multi -purpose, EPA-registered, insecticidal wood
preservative designed to protect exterior untreated or
pressure-treated wood in below ground, ground contact,
fresh water contact or above ground installations.
CopperCoat prevents attack from termites and other wood
boring insects while protecting against rot and decay. Its
anti-wicking property resists moisture absorption through
end cuts for greater control of dimensional warping,
splitting and end-checking. Plus, its paintable /stainable
formula makes this product an excellent preservative
primer for wood roofing, millwork and trim.
WoodLife CopperCoat uses include, Multi-purpose
preservative for below ground contact, fresh water contact
or above ground installations. Use on all species of
untreated or pressure-treated lumber and plywood. Ideal
for docks and piers, fence posts, poles, pickets and rails,
construction posts, foundation sills, stairs, porches and
steps, landscape timbers, planters, arbors, trellises,
gazebos, storage sheds, roofing shingles or other exterior
wood exposed to moisture, weather or wood destroying
insects. Excellent pre-paint / pre-stain primer for wood
windows, doors and frames, siding shakes and shingles or
other above ground exterior wood exposed to moisture
contact. Also highly recommended for pressure treated
wood and end cut protection, especially on decks.
SPECIAL FEATURES
 Prevents attack from termites, powder post beetles
and other wood boring insects.
 Protects against rot and decay by inhibiting mold,
mildew, and staining fungus growth on the wood
surface.
 Controls moisture damage, including swelling,
shrinking, warping, splitting and end-checking.
 Water-based formula allows for fast; easy clean up
with soap and water.
 Transparent, natural green color can be over-coated
with oil-base primer, paint or stain.
PRODUCTS .
SKU Description
1901 1-Gallon
1902 5-Gallon
PRODUCT APPLICATION .
Do not tint, dilute or mix this product with any other
product. Use as a pre-treatment, before wood is installed
in ground or fresh water contact. DO NOT APPLY at sites
on or near water or wetlands.
.PRODUCT APPLICATION (cont.) .
SURFACE PREPARATION
Wood surface must be dry and free of dust, dirt, debris
and standing water. Product will adhere to dry or damp
(not soaking wet) surfaces. See surface preparation
instructions below for your particular wood type.
NEW WOOD – Check for the presence of surface barriers
such as paraffin wax (pressure treated wood) or mill glaze
(Cedar, Redwood, etc.) by performing a Splash Test (see
instructions below). If barrier is detected, use Wolman
®
Deck & Fence Brightener to clean surface, then conduct
Splash Test again before applying this product.
WEATHERED WOOD – Surface must be dry and free of
any colored paints, stains, varnishes or built-up, clear
finishes, as well as ground-in-dirt, grayed surface fibers
and tannin, algae or mildew stains. Use Wolman
DeckStrip
®
or Wolman Deck & Fence Brightener to remove
old finishes and surface contaminants, then conduct
Splash Test (see instructions below) before applying this
product.
SPLASH TEST – Sprinkle a few drops of water on surface
to be coated. If the water is absorbed rapidly, surface is
ready to receive coating. If the water beads or is not
absorbed, a surface barrier exists which must be removed.
Apply Wolman Deck & Fence Brightener and then re-test
APPLICATION
Before You Start – To minimize clean-up afterward, cover
surrounding landscaping and exposed brick, glass,
aluminum and vinyl siding with cardboard, plastic or cloth
tarps. Protect plants, shrubs and vegetation from over-
spray. Stir or shake well before using.
Conditions - Apply when outside temperatures are
between 50-90°F (10-32°C), and when no precipitation is
expected within 24 hours. If surface is in direct sunlight
and hot to the touch, dampen with fresh water to cool.
Homeowner Do-It-Yourself Method
BRUSH – Nylon or synthetic bristle.
ROLLER – Short-nap style.
PUMP-STYLE SPRAYER – Wolman
®
BackSaver
®
2
Gallon Sprayer is recommended.
DIP TREATMENT – see Recommended Coverage and
follow directions.