Product Manual
Your choice of a Wolo “battery powered” warning light is the perfect choice used for roadside assistance, snow
plowing, boating, camping and etc. Wolo manufactures this product with the finest materials. Each light is tested
to meet our high standards before it is packaged, to ensure a perfect working light. Our quality workmanship and
components are Wolo’s assurance of a product that will give years of dependable service. If you need help using your
new Wolo work light, our technicians are available to answer your questions, Monday thru Friday, from 9 AM to 4 PM
EST at 1-888-550-4676.
IMPORTANT: Read this instruction sheet before using the warning light to ensure safe operation and storage.
Always follow the simple guidelines below and use the same caution and care that would be given to any electronic
or electrical device.
MAGNET MOUNTING:
IMPORTANT: Vehicle roof construction varies for most vehicles as well as driving conditions. The vehicle should
never be driven with this warning light magnetically mounted. It is possible that the light could dislodge off the
mounting surface and cause damage, injury or death. Ignoring this warning shall be the sole responsibility of the user
and or vehicle owner.
IMPORTANT: The magnets’ holding power to the mounting surface is dependent upon the following:
flatness, thickness, condition and finish of the mounting surface. For maximum magnet strength, follow these
recommendations:
A. The vehicle’s mounting surface should be kept clean and free of wax, dirt, dust and foreign particles.
B. The bottom of the magnets’ rubber cover should be kept clean and free of wax, dirt, dust and foreign particles.
C. Always make sure that the mounting surface is flat and the light’s magnet base is secured to the mounting surface.
D. Never attempt to secure the magnet to a vehicle that has fabric or vinyl covering the mounting surface.
E. Once you have located the desired mounting location, you should make sure the lens is unobstructed so that the
light can be seen 360 degrees.
BATTERY INSTALLATION:
1. Open the battery compartment by turning the magnet base
counter clockwise. Figure 1B.
2. Install two (2) “D” batteries (not included) as shown in Figure 2.
Do not secure magnet base to light.
SETTING-UP OF WARNING LIGHT & TESTING
IMPORTANT: PORTALIGHT has a built-in photocell which will
automatically turn the warning light ON at night and turn OFF in day
light, when the photocell switch is positioned to ON.
3. In the battery compartment, there is a on/off slide switch that
controls the photocell. Place the switch in the off position. Fig. 2A.
4. Press and release the yellow ON/OFF push button and the light
will turn on. Fig. 1A.
5. There are four (4) different light patterns to choose from. In the
battery compartment press and release the push button switch
and the light pattern will change. Fig. 2B.
6. Select the light pattern that you want to use. The light pattern will
remain in the memory until such time that the user decides to
change it.
7. If the user wants the warning light to turn on automatically at
night and turn off automatically in day light, make sure the yellow
ON/OFF switch is ON then position the photocell slide switch to
ON. Fig. 2A.
8. When the photocell switch is positioned to OFF the light will be
controlled by the yellow push button ON/OFF switch.
9. Secure the magnet cover to the light.
The PORTALIGHT warning light is ready to use.
OPERATING INSTRUCTIONS FOR
PORTALIGHT
™
MODEL 3020-A
Fig. 1
Fig. 2
1B
Battery
Compartment
Turn counter
clockwise to open
2A
ON/OFF slide
switch controls
the photocell
2B
Push button switch changes
the light pattern
Install
2 “D”
batteries
Battery Compartment
1A
Yellow ON/OFF
push button