THERMOSTATIC SHOWER MANUAL Or ◆ Install the handheld shower head Step 1 Step 3 Step 2 Step 1. Screw the thread into the water pipe inside the wall. Step 2. Screw the main body into the thread. Step 3. Rotate and fix with the alien wrench Step 4 Step 4.
Product List Product List Please check the accessories with following table,if there is anything missing , please contact customer service immediately. Please check the accessories with following table,if there is anything missing , please contact customer service immediately.
Body Sprays 1/2" 4 3/5 3 1/10 4 3/10 2 3/5 2 1/10 6 2/5 1/2" 3 2/5 Overhead Shower According to the basic size of the embedded box, use a special tool to open the main hole on the solid wall.As shown in the figure, it should be considered that the depth of the wall after the final treatment and the bottom of the opening is 3 1/10-3 3/5 inch Between, the width is between 4 7/10-4 9/10inch, and the height is between 6 9/10-7 1/10inch.
Make sure that the pipe connection is correct and that the test water has no leakage. After the installation of the other embedded components of the showeris completed, the embedded box and the pipeline are sealed and fixed with filler. Open the water source to test whether the left and right inlet pipes are connected tightlyand without leakage. After the inlet pipe is tested, adjust the flow switch to be on to test whether the mixed water outlet pipes are tightly connected without leakage.
Take out the spirit level installation cover box and test water cover as shown in the figure As shown in the figure, install the control valve, and then install the switch handle. Pay attention to the red pen mark. Use the small hexagon wrench included in the package to fix the switch handle clockwise on the valve body of the control valve. The direction of the handle stem is 38 °. position.
◆ Install the massage shower Step 2 Step 1 NPT1/2 Step 3 G1/2 Step 1, Wrap the tooth tube NPT1/2 with teflon tape and screw into the wall Step 2, Cut off excess part with a saw Step 3, Cover the decoration cup, then screw the massage shower in Step 2 Step 1 NPT1/2 G1/2 ◆ Install the rain shower head HOT COLD Step 1 Step 2 Step 3 Step 1. Wrap the teflon tape on the thread Step 2. Clockwise rotation of the ceiling arm to the pipe Step 3. The rain shower head connects to the arm.
