Installation & Assembly

Note: Do not disassemble this product under non-professional guidance.
Pictures are for reference only. All the spare parts are subject to the
actual product.
Basic Size
According to the basic size of the embedded box, use a special tool to open
the main hole on the solid wall.As shown in the figure, it should be considered
that the depth of the wall after the final treatment and the bottom of the
opening is 3 1/10-3 3/5 inch Between, the width is between 4 7/10-4 9/10inch, and
the height is between 6 9/10-7 1/10inch.
Mixed
water
outlet
pipe
Hot
water
inlet
pipe
Cold
water
inlet
pipe
Mixed water outlet
pipe
Cold
water
inlet
pipe
Hot
water
inlet
pipe
Mixed
water
outlet
pipe
Mixed
water
outlet
pipe
Mixed water
outlet pipe
Mixed
water
outlet
pipe
Mixed
water
outlet
pipe
Mixed water
outlet pipe
Mixed
water
outlet
pipe
Cold
water
inlet
pipe
Hot
water
inlet
pipe
As shown in the figure, the inlet and outlet pipes are embedded. Pay attention to the correct
direction of installing the embedded box. Be sure to mark the top of the baffle upward, and
the vertical direction of the embedded box. The lower left interface is connected to the hot
water pipe. The interface is connected to the cold water pipe, the upper left interface is
connected to the top spray pipe, and the upper right interface is connected to the handheld pipe.
Note: Please strictly follow the cold and hot water pipes shown in the diagram to connect
the main body cold water and hot water to the correct position to avoid reverse installation.
1/2inch water pipes
Body Sprays
1/2" 1/2"
Overhead Shower
TO Hand Shower
Hot
Cold
3 2/5
3 1/10
2 3/5
4 3/5
4 3/10
2 1/10
6 2/5
6 9/10