Installation & Assembly

As shown in the figure, install the control
valve, and fix the thermostatic control valve
with the screws that originally removed the
flap. After fixing the control valve, open
the water pipe switch. Please pay attention
to check whether there is any leakage between
the control valve and the base. Control the
valve and check whether the 6 rubber rings
under the control valve are installed
correctly. After the inspection, please
reinstall the control valve. Then test
whether the diverter spool is normal. The
next step is to test whether the water
temperature is 38 ° ± 1 under normal use.
If there is high or low temperature, please
check if the red pen mark on the thermostat
spool is aligned. If the temperature is not
constant, please check whether the hot and
cold water pipes and the hot and cold water
inlets of the main body are installed
correctly. After testing all functions,
please install the panel and the switch
handle. Make sure that the direction of the
handle bar is facing the 38 ° position.
Take out the spirit level installation cover box and test water
cover as shown in the figure
As shown in the figure, install the control valve, and then install the switch handle.
Pay attention to the red pen mark. Use the small hexagon wrench included in the package
to fix the switch handle clockwise on the valve body of the control valve. The direction
of the handle stem is 38 °. position.