User's Manual

Wireless Portable Bluetooth Speaker
Mode No.: DOSS SoundBox
User Manual
I. Introducon
Status indicators
II. Package content
III. Product overview
IV. Preparaon
V. Pairing the wireless speaker with your smart device
VI. Answering and ending a call using your speaker or
mobile phone
6. Power buon: Long press to turn the device on and off.
7. Auxiliary Φ3.5mm jack : Use it for cabled playback with compable
devices.
8. TF card: Use it for TF card (with music) playback.
9. Charging port: Plug the supplied USB cable into this port to recharge
the built-in baery.
10. LED charging indicator.
• Charging : Steady Red.
• Fully charged : Steady Green.
Thank you for purchasing the DOSS SoundBox Wireless Portable Bluetooth
Speaker with Bluetooth and Hands free funcon. We encourage you to
read this instrucon guide thoroughly to get the most out of this innovave
wireless portable speaker.
• One wireless portable speaker
• USB charging cable
• Φ3.5mm auxiliary cable
• Travel waterproof pouch
• User manual,Warranty card,Contact card
1. Mode switch: Touch to toggle play mode among Bluetooth,
TF Card and Aux-in connecon.
2. In Bluetooth mode/TF mode, touch to skip backward.
3. Play/Pause and handset buon
• In Bluetooth mode,touch to answer or end a call. Touch for 3
seconds to reject a call.
• In Bluetooth mode, touch to play/pause your tune. Touch for 3
seconds to disconnect with your device.
• In TF mode, touch to play/pause your tune.
4. In Bluetooth mode/TF mode, touch to skip forward.
5. Volume control:
• Clockwise rotaon to increase the volume.
• Counterclockwise rotaon to decrease the volume.
Center indicator/
Control buon
Baery status
indicator
Flashing blue
Steady blue
Steady red
Steady green
Indicates that the speaker
has entered into the pairing
mode and it is ready to be
the first me
Indicates that the device is
successfully paired
Steady red
Steady Green
Indicates that the device has
switched to the auxiliary
input mode
Indicates that the device has
switched to the TF mode
Baery is charging
Baery is fully charged
• Use the supplied USB cable to charge your portable speaker directly
from your computer or device with a micro USB port.
• Make sure that the speaker is fully charged before using it for the
first me.
• The portable speaker baery has to be inially charged for at least
12 hours. Thereaer, the baery will take from 2 to 3 hours to recharge.
• While charging, the LED glows red. When the baery has reached full
capacity, the LED will change to green.
• To turn on the speaker, press and hold the power buon for several
seconds. Press and hold the power buon once more to turn off
the device.
Note： The speaker will automacally shut down without any audio
input in 15 minutes.
1. Place your smart device and wireless speaker no more than one meter
away from each other.
2. Press the power buon located on the back of the speaker for several
seconds to turn it on.
3. Set your smart device to “discover” the wireless speaker. Upon
powering on, a tone will be heard, the blue LED will start flashing,
accompanied by a prompt nofying that the speaker has entered into
the pairing mode.
4. Enabled Bluetooth on your device and choose DOSS SoundBox from
the list.
5. If pairing is successful, the LED will change to steady blue and your
phone will confirm that the connecon has been established. If the
pairing process fails aer 60 seconds, please repeat steps 1 through
5 described above.
1. When there is an incoming call, the speaker will generate a tone and
a verbal noficaon to alert you of this event.
2. Briefly press the Handset buon to pick up, long press to reject.
You may also press the answer buon on your smart phone to take the
call using the speaker.
3. Speak with a clear voice right into the built-in microphone located on
the front secon of the speaker.
4. To end a call, tap the Handset buon once again. Likewise, you
may also end the call directly using the command on your cell phone.
5. When listening to music using your smart phone, playback will resume
automacally once the call has ended.
VII. Product specificaons
Product type: Wireless Portable Bluetooth Speaker with Built-in
Microphone
Output power: 6W x 2
Driver unit: 1.5 inch speaker x 2 + 2.6 inch passive radiator
Frequency response: 100Hz-18kHz
Signal to noise rao: ≤ 55dB
Unit weight: 560 g
Unit dimension: 6.6 x 2.7 x 2.9 inch
Warranty: One-year limited
VIII. Power
X. Warning
IX.Wireless/Networking
• Baery type: Li-ion 3.7V, 2200mAh
• Input:5V 1A
• Baery charge up me: 3 hours approximately (when fully depleted).
• Baery playback me: up 12 hours (duraon me may vary depending
on the volume level used and usage paerns).
• Bluetooth specificaon: V4.0+EDR, backwards compable with previous
Bluetooth versions
• Profiles supported
• A2DP (Advanced Audio Distribuon Profile)
• Maximum operaon range: 10 meters / 33 
• Do NOT drop, hit or shake the device.
• Do NOT disassemble, repair or modify the Bluetooth speaker by yourself.
• Do NOT use cleaning products that contain benzene, solvents or alcohol.
• Do NOT expose the Bluetooth speaker to excessive heat or to direct
sunlight for long periods of me.
• Do NOT store the device in a place with high humidity or dust.
• Do NOT place heavy objects on top of the Bluetooth speaker.
• Do NOT use near a microwave oven or wireless LAN products.
正反面印刷
SIZE：95 X 148NN
1
2
6 7 8 9 10
3
5
4
Backlit touch-sensive buons
Wonders Technology Co.,Ltd
Email:[e-mail]