User Manual

After-Sales Service
3. Drill
FAQ
You can use an electric drill to make holes at the location you
marked earlier.
For brick, concrete or plaster surfaces, plastic anchors must be
used. Please use a hammer to install the anchor in place.
For wooden surfaces, you can omit the anchor and drive our
standard tapping screws directly into the surface using an
electric screwdriver.
4. Install the panel bracket arm
Please use an electric screwdriver to fix the bracket arm on the
wall with standard tapping screws and tighten it clockwise.
It is not recommended to use a manual screwdriver to avoid
improper installation due to insufficient force; it is not
recommended to install on plastic or ceramic tiles or glass,
because plastics are easily deformed, ceramic tiles and glass
5. Install solar panel
Install the solar panel on the bracket arm to make sure it is
properly installed.
Note: You can adjust the angle of the solar panel for better
sunlight coverage. Simply loosen the adjusting screw on the
mounting arm, adjust it to the desired angle, and then tighten
the screw again. You need to find the right direction to install
the solar panel, and you will hear a slight “click” when it is
inserted in place.
6. Plug in the charging cable
Finally, correctly insert the charging cable of the solar panel into
the corresponding micro port on the back of the battery camera.
Now, the entire installation process of the solar panel is
completed.
If the above solutions cannot solve your problem, please contact
our after-sales support team.
Email:[e-mail]/ Online service on AIWIT APP
27 26