User Manual

3. Match the battery camera in the AiWit APP
WONGKUO Battery Camera will start automatically and enter
the network matching mode with a voice prompt when the fully
charged battery pack is correctly installed and the insulation
sticker is removed; to match the battery camera, follow steps
(1) Open the Aiwit App on your mobile phone and log into the
previously registered email account.
(2) Select the homepage + icon in the APP, and click “Add Camera”.
+
Add New Device
(3) Go to the next step, select Battery Camera 2 and click “OK”.
(4) (If your WongKuo Battery Camera is in normal network matching
mode, the red light on the front of the camera is flashing, and the
camera speaker has corresponding voice prompt, please ignore
Step 4.) Remove the battery pack and reinstall it, press and hold
the “Setup” reset button on the back of the camera until the red
light flashes, release the “Setup” reset button, and enter the next
step after hearing the voice prompt of network matching.
(5)
Setup
Go to your 2.4G WiFi network page, enter your WiFi
password, and then click “Next” (Please confirm that
the WiFi connected to is a 2.4G network, and the
WiFi name is English or English plus numbers, and
there is no space; the WiFi connected to the mobile
phone and the WiFi used for matching are the same
network with the same name; WONGKUO Battery
Camera does not support 5G network matching).
(6)
Make sure that your WONGKUO Battery Camera is
connected to the WiFi network correctly and click
“OK” button to enter the next step.
Confirm that the WiFi
connection is correct
7 6