STONE-FIRED COOKING EQUIPMENT RFG-IR-W, GGW Gas/Gas Wood Oven Installation and Operation Manual Additional Copies Available Upon Request 1801 W. Bakerview Rd. Bellingham WA 98226 www.woodstone-corp.com Toll-Free 800-988-8103 Tel. 360-650-1111 Revised October 2007 Fx.
Wood Stone WS-MS-(4,5,6,7)-RFG-IR-W Gas/Gas Wood Oven Installation and Operating Instructions DO NOT THROW THIS MANUAL AWAY RETAIN THIS MANUAL FOR FUTURE REFERENCE. Additional copies of this manual and prompt responses to service/maintenance questions are available from Wood Stone @ 800-988-8103. IMPORTANT: Consult your local gas supplier for a statement outlining a procedure to be followed in the event you smell gas. Post the statement in a prominent location.
RFG-IR-W Oven Installation and Operation Manual UNLOADING AND MOVING LIFTING THE OVEN 1. USING A CRANE The oven arrives with four lifting eyes attached. When craning a Wood Stone oven, use a spreader bar with a two-legged sling rigged on each end. The spreader bar should be of a sufficient length to keep the sling from contacting the oven. NOTE: Once lifting eyes are no longer needed, remove the lifting eyes one at a time AND BE SURE TO REPLACE THE BOLTS THAT ATTACH THE OVEN TO THE STAND. LIFTING EYES 2.
RFG-IR-W Oven Installation and Operation Manual INSTALLATION CLEARANCES IF THIS OVEN IS NOT PROPERLY INSTALLED A FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THESE INSTALLATION INSTRUCTIONS. A MAJOR CAUSE OF OVEN RELATED FIRES IS FAILURE TO MAINTAIN REQUIRED CLEARANCES (AIR SPACES) TO COMBUSTIBLE MATERIALS. IT IS OF UTMOST IMPORTANCE THAT THIS OVEN BE INSTALLED ONLY IN ACCORDANCE WITH THESE INSTRUCTIONS.
RFG-IR-W Oven Installation and Operation Manual INSTALLATION CLEARANCES The following clearance information applies to all Wood Stone Mountain Series(non-stucco) Ovens Any facade materials above and 6" to either side of the doorway of the oven, must be NON-COMBUSTIBLE.
RFG-IR-W Oven Installation and Operation Manual FACADE DETAILS Wood Stone Mountain Series (MS-Models) ovens carry an ETL Sanitation listing. The oven interior only is ETL listed to NSF/ANSI Standard 4 This means that the surfaces of the oven which are meant to be left exposed after the facade has been put in place, have been evaluated from the standpoint of sanitation and food safety and found to comply with NSF/ ANSI Standard 4.
RFG-IR-W Oven Installation and Operation Manual Outdoor Installations Outdoor Installations The Mountain Series (MS and MH) model ovens are ETL approved for outdoor installation. When installed outdoors, the open area beneath the oven must be enclosed, with the exception of the perforated area on the front service panel for air intake. The oven may be installed in a weatherproof enclosure. If so be sure to maintain all clearances and adhere to the installation requirements included in this manual.
RFG-IR-W Oven Installation and Operation Manual GAS SPECIFICATIONS GAS The Wood Stone Gas ovens are equipped with a 3/4" NPT gas connection. Have a licensed gas installer provide the hook-up and test all fittings and pipe connections for leaks. Use approved gas leak detectors (soap solutions or equivalent) over and around the fittings and pipe connections.
RFG-IR-W Oven Installation and Operation Manual GAS SPECIFICATIONS Hourly Natural Gas BTU input rates for Wood Stone gas ovens Model Hourly BTU Input Rate WS-MS-4-RFG-IR-W-NG 115,000 WS-MS-5-RFG-IR-W-NG 188,000 WS-MS-6-RFG-IR-W-NG 188,000 WS-MS-7-RFG-IR-W-NG 220,000 Hourly Propane BTU input rates for Wood Stone gas ovens Model Hourly BTU input Rate WS-MS-4-RFG-IR-W-LP 102,000 WS-MS-5-RFG-IR-W-LP 159,000 WS-MS-6-RFG-IR-W-LP 159,000 WS-MS-7-RFG-IR-W-LP 227,000 Wood Stone recommends that the appliance’s ind
RFG-IR-W Oven Installation and Operation Manual ELECTRICAL SPECIFICATIONS ELECTRICAL Have a licensed electrician wire the transformer terminal strip with a 120V, 15 amp lead. Electrical diagrams are located directly to the right, behind the removable service/intake panel of the appliance as well as inside the control box and also on page 25 of this manual. See page 14 of this manual for location of the transformer housing.
RFG-IR-W Oven Installation and Operation Manual OVEN VENTING OVEN VENTING The following are the manufacturer’s recommendations for venting the Wood Stone MS (Mountain Series) RFG-IR-W ovens. It is never appropriate to use “B vent” in any part of an exhaust system connected to a Wood Stone oven. All ducting material must be manufactured to the specifications of a grease duct and a listed building heating appliance chimney.
RFG-IR-W Oven Installation and Operation Manual OVEN VENTING (continued) Allow sufficient opening between any facade and the inside edge of the front of the hood to allow for filter removal and hood cleaning. Views of installation of a Wood Stone hood. Note that the notch of the hood is even with the front edge of the oven. The hood should be installed in accordance with the hood manufacturer's instructions, and with NFPA 96 and/or the applicable local and national codes. 3.
RFG-IR-W Oven Installation and Operation Manual ASSEMBLY ASSEMBLY 1. Mount the oven mantle (if provided) using the hardware provided. on page 14). 2. Mount the stainless steel toe kick to the front of the oven stand, near the floor using the hardware provided (See figure on page 15). If your oven was shipped with a lower facade extension there is no toe kick required. 3.
RFG-IR-W Oven Installation and Operation Manual MANTLE MOUNTING Whether mounting a stainless mantle or a bracket for a granite mantle, the initial steps are the same. 1. Begin by installing the threaded studs into the clip nuts below the oven doorway (3 or 4 turns is sufficient). 2. Next, place two spacer washers on each stud. 3. Position the mantle (or bracket) on the oven, making sure that the rear flange rests on the floor of the oven (you may need an extra pair of hands at this point). 4.
RFG-IR-W Oven Installation and Operation Manual ASSEMBLY Standard Front Panel and Toe Kick View of Throttle Assembly The throttle knob position can be adjusted inward or outward by loosening the clamp and sliding the throttle knob assembly to the desired position. Be sure to retighten the clamp once the throttle knob is in the desired position.
RFG-IR-W Oven Installation and Operation Manual ASSEMBLY Ovens Equipped With Optional Lower Extension October 2007 Questions? Call Wood Stone at 800-988-8103 16
RFG-IR-W Oven Installation and Operation Manual Stucco TRADITIONAL STUCCO MIX 1 part masonry cement 1 part regular cement 5 parts sand STUCCO PREMIX IS PROBABLY AVAILABLE AT YOUR LOCAL LUMBER YARD OR BUILDING SUPPLY 1 part premix 2 parts sand MINIMUM STUCCO APPLICATION IS 1" This figure depicts the application of stucco on a Wood Stone oven. Use no less than one inch of stucco coating to cover all exposed metal lathing on the oven.
RFG-IR-W Oven Installation and Operation Manual INITIAL STARTUP INITIAL OVEN STARTUP FIRST DAY 1. Make sure main gas supply is on (valve parallel with gas line). 2. Make sure the switches on the Honeywell control gas valves are in the on position. 3. Remove the night door(s). Push ON/OFF button on controller. It may take a while for the gas to purge all the air from the gas lines. 4. Allow oven to operate at FACTORY SETTINGS for 1 hour (thermostat set at 200 degrees, radiant flame at its lowest setting).
RFG-IR-W Oven Installation and Operation Manual OVEN STARTUP Never run the oven with the night door(s) in place. DETAILED DAILY OVEN OPERATION IMPORTANT: If at any time you feel that either or both of the burners are not operating properly, TURN THE OVEN OFF and call for service. Before servicing, disconnect the electrical supply at the breaker and turn off the gas supply at the appliance’s individual gas shutoff valve. In the event of a power failure, no attempt should be made to operate the oven.
RFG-IR-W Oven Installation and Operation Manual OVEN OPERATION 4. ADJUSTING THE FLOOR SET-POINT To adjust the oven's thermostatic floor temperature setting, simply press the arrow button corresponding to the direction in which you would like the setting to go. If the thermostatic set point is raised above the actual hearth temperature, the underfloor burner should activate. * It is only possible to program the floor’s thermostatic hearth set point to temperatures from 200 to 700 degrees F.
RFG-IR-W Oven Installation and Operation Manual CONTROLLER DIAGRAM POWER DOME FLAME HEARTH HEAT HEARTH TEMPERATURE HEARTH SET POINT Push ON/OFF button to light burners. Presser le bouton ON/OFF pour allumer le bruleur. ON OFF Push ON/OFF button to turn burners off. Presser le bouton ON/OFF pour arreter le bruleur F C WAIT 5 MINUTES BEFORE RELIGHTING ATTENDRE 5 MINUTES AVANT DE RÉALLUMER 1-800-988-8103 www.woodstone-corp.com This figure shows the face of the gas oven controller.
RFG-IR-W Oven Installation and Operation Manual USE OF WOOD IN THE OVEN When burning wood in a Wood Stone RFG-IR-W or RFG-W model oven, the fire should be placed to one side of the oven chamber, as close to the door opening as is possible (this is often described as the 8 o'clock or 4 o'clock position). Burn a maximum of 15 Lbs. of wood per hour. If flames spill out of the doorway, or the temperature exceeds 850 you are over-firing.
RFG-IR-W Oven Installation and Operation Manual PERIODIC THERMAL CLEANING ESTABLISHING A THERMAL CLEANING SCHEDULE Wood Stone ovens are typically operated at temperatures which preclude the need for cleaning of the interior walls and ceiling (the dome) of the oven. If however, you routinely operate the oven at floor temperatures lower than 450 degrees Fahrenheit, you may notice a buildup on the interior walls and/or ceiling of the oven.
RFG-IR-W Oven Installation and Operation Manual SAFETY CONSIDERATIONS IMPORTANT SAFETY CONSIDERATIONS Solid-fuel exhaust contains creosote and other substances that accumulate in ducting, creating a risk of fire. The rate of accumulation will vary with respect to flue gas temperature, wood type and moisture content. Frequent, regularly scheduled, thorough flue cleaning is the best way to minimize the risk of flue fires.
RFG-IR-W Oven Installation and Operation Manual TROUBLESHOOTING Quick Troubleshooting Guide Problem Solution Controller will not turn on. 1.Incoming power to oven turned off. Check circuit breaker for circuit supplying the oven. Check that any wall switches external to the oven that control oven power are turned on. Check that any interlocks external to the oven are turned on. and that exhaust fan is on. 2. If control still does not turn on, please contact Wood Stone for assistance.
RFG-IR-W Oven Installation and Operation Manual ELECTRICAL DIAGRAM 100/120 VAC RFG-IR-W Electrical Diagram October 2007 Questions? Call Wood Stone at 800-988-8103 26
RFG-IR-W Oven Installation and Operation Manual Operation Sequence Burner Operation Sequence GG-W or RFG-IR-W Oven - Touchpad Controller Power On SV2 valve powers igniter and opens pilot valve for radiant (rear) burner. Pilot Lights Pilot does not light, SV2 times out Floor Temp. above set point, then controller does not power SV1 (underfloor burner).
RFG-IR-W Oven Installation and Operation Manual INTERLOCK Interlock of Oven Control to an Exhaust Fan This connection is intended to interrupt power to the oven until the fan is turned on. S1 is a double pole - single throw switch (provided by others) that interrupts incoming power to both the oven and the fan. The intent is to prevent the operation of the oven in the event the fan is shut off.
Fuelwood Facts What type of wood should you use to fire your solid-fuel cooking equipment? The answer to this question depends on several considerations; geographical location, availability and relative cost of various fuelwood species and individual preferences regarding the flavor qualities of various wood types. There are a wide variety of good fuelwood species in all geographic locations.
RFG-IR-W Oven Installation and Operation Manual LIMITED WARRANTY Wood Stone warrants its equipment to the original purchaser against defects in material or manufacture for a period of one year from the original date of purchase, subject to the following exclusions and limitations. All WARRANTY SERVICE MUST BE PRE-APPROVED BY WOOD STONE. Please contact the factory first. Please call 1-800-988-8103 or 360-650 1111 7 days a week.
