Specifications

14
An ongoing program of product improvement may require us to change
specifications without notice. (-W). Revised September 2009
Wood Stone Corporation
1801 W. Bakerview Rd.
Bellingham, WA 98226 USA
Toll Free [phone]
Tel [phone]
Fax [phone]
[e-mail] or visit www.woodstone-corp.com
Mountain Series Installation and Operation Manual
mantLe mountinG
The initial steps are the same for mounting either a stainless mantle or a bracket for a granite mantle.
2. Next, place (2) spacer washers
on each stud.
4. Finally, place one final washer
(stainless steel) and a cap nut on
each stud. Tighten the cap nuts
so the mantle is securely held in
place.
5. Using the high temperature silicone (provided), fill any gaps between the oven hearth and the mantle flange. Gaps
between the mantle flange and the stainless steel doorway frame may also need to be filled with a small amount of the
silicone compound.
INSTALLATION OF GRANITE - After completing the steps outlined above, apply a generous amount of silicone adhesive
(provided) to the top of the steel mantle bracket.
Put the stone in place and apply light
pressure to seat it properly. Make sure that
the angle in the granite lines up with the
angle in the bracket. Allow the adhesive
to set for several hours before filling
any gap between the stone slab and the
metal bracket with the silicone compound
(provided). Clean up any adhesive and/or
silicone before it dries!
1. Begin by installing the threaded
studs into the clip nuts below the
oven doorway (3 or 4 turns is
sufficient).
3. Position the mantle (or bracket)
on the oven, make sure the rear
flange rests on the floor of the
oven (you may need an extra pair
of hands).
MANTLE MOUNTING