Installation Guide

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

Massage cleaning 30s

Energy saving

Remark

Keep pressing “STOP” button for more than 3S to enter energy saving mode, the indicator light will

be off and energy saving light will be on. Keep pressing “STOP” button again for more than 3S to

exit energy saving mode, the indicator light will be on and energy saving light will be off.

· The automatic function of factory default setting is middle level for water volume, nozzle position,

water temperature, air temperature, seat temperature.

· The Auto function mode will be off if the ueser presses other buttons during operation of auto

functions and shift to operate the functions of the buttons.

Usage Instruction

Energy saver

Auto function

Automatic stop

Auto rear cleaning

Rear cleaning 20s

Dry 180s

Rear cleaning 40s

Auto front cleaning

Front cleaning 20s

Front cleaning 40s

Dry 180s

Automatic stop

STOP

HOLD TO ECO

Under energy saving mode, seat temperature is low(level 1) to achieve energy saving. (Note: If the

seat temperature before energy saving is neutral, keep the neutral after energy saving)

Energy saving mode will be suspended and goes to function mode if someone uses the seat in the

middle of energy saving. The seat starts to heat immediately (without closing the seat temperature),

and the energy saving mode is restored after the human body leaves the seat.

· Short press on the remote control button " ", " " can achieve male hip wash and female bidet

wash, fully automatic and convenient use. The user can firstly set the water volume, nozzle position,

water temperature gear position and air temperature gear position. After the setting is completed,

press the corresponding automatic key 3s to save the setting. The next time you use it, you can call

the saved key by pressing the corresponding automatic key. Set the automatic function to enable

automatic cleaning and drying in the whole process.

Tips: Certain models don’t have drying function.