E G D E G D I R INSTALLATION MANUAL B D WOODBRIDGE R O O W Solid Surface Shower Wall Kits and Panels R E G R D I R D R E G B D O O W E G R D D I R B D O O W E G Customer Service Phone: 562-229-0088. (Monday - Friday 9 AM - 5 PM Pacific Time) Or Email: help@woodbridgebath.com www.woodbridgebath.com 20200909 REV.
WOODBRIDGE R !!!Consult your local building codes with questions on installation compliance standards. Building and plumbing codes may vary by location, Woodbridge Bath is not responsible for code compliance standards for your project!!! Before You Begin Woodbridge shower wall panel can be installed in both showers and alcove tub installations. Can be cut to fit any application.
WOODBRIDGE R 1. Woodbridge Shower Wall Panels are designed to be installed over a solid substrate such as green board, cement backer board, or Densshield. The substrate should be clean, dry, and are of dust and debris. 2. If installing a new bathtub or shower base prior to Woodbridge shower wall panel installation, follow the manufacturer’s instructions, and install the tub or base level and square to the walls. 3. Turn off the water supply and complete any plumbing modifications prior to installing your.
WOODBRIDGE R L1 R1 Vertical Plumb Line L2 R2 D1 D2 D3 L3 R3 How to Measure: Draw a vertical plumb line directly on the middle of the sheet- rock from top to bottom of wall. Now draw a horizontal level line crossing the plumb line about halfway up the wall. Record mea- surements left from the vertical line to corner at top, middle and bottom (L1, L2, L3), then right from the vertical line to corner (R1,R2, R3.) Now record measurements down from the horizontal line to the tub (D1, D2, D3.
WOODBRIDGE R 2. Installation of wall panel with plumbing fixtures. A. Hold side panel as close to plumbing wall as possible. Scribe and trim the inside edge and bottom edge against the shower base for best fit before measuring, marking, and cutting holes for plumbing fixtures. The overall depth of the side wall panels can also be trimmed down to fit the opening or the depth of your shower base. www.woodbridgebath.
Inside Wall WOODBRIDGE R Shower Base NOTE: You will be able to make smaller adjustments to the panel for a more accurate fit after the holes are cut and your panel can be firmly pushed into the corner. Keep I mind the size and coverage of the trim kit and escutcheons. B. For each hole to be cut, measure the vertical distance between the center of the plumbing fixture and the shower base. Measure the horizontal distance between the center of the fixture and the installed back wall panel.
WOODBRIDGE R R W E G D I R B D O O B D O O W F. A small amount of silicone should be applied around the back of each R plumbing hole penetration. E G 3. Installation of opposite side wall panel. D I R A. Use same procedures as in steps 2.A-2.F except that no holes will be drilled in this panel. Dry fit first, and then apply silicone to seal the back wall and shower base corner, and adhesive to panel as you did on previous side panel installation. B D O O B D O O W 4.